X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Date:	Tue, 29 May 2012 16:40:50 -0700
From:	Colin D Bennett <colin AT gibibit DOT com>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] rectangular pad with hole? howto?
Message-ID:	<20120529164050.75b044cc@svelte>
In-Reply-To:	<20120529161842.59363805@svelte>
References:	<20120529223834 DOT GA28710 AT nome03 DOT eecs DOT oregonstate DOT edu>
	<20120529161842 DOT 59363805 AT svelte>
X-Mailer:	Claws Mail 3.8.0 (GTK+ 2.24.10; x86_64-pc-linux-gnu)
Mime-Version:	1.0
X-AntiAbuse:	This header was added to track abuse, please include it with any abuse report
X-AntiAbuse:	Primary Hostname - gator297.hostgator.com
X-AntiAbuse:	Original Domain - delorie.com
X-AntiAbuse:	Originator/Caller UID/GID - [47 12] / [47 12]
X-AntiAbuse:	Sender Address Domain - gibibit.com
X-BWhitelist:	no
X-Source:
X-Source-Args:
X-Source-Dir:
X-Source-Sender:	(svelte) [65.61.115.34]:61299
X-Source-Auth:	colin AT gibibit DOT com
X-Email-Count:	8
X-Source-Cap:	c2t5bGVuO3NreWxlbjtnYXRvcjI5Ny5ob3N0Z2F0b3IuY29t
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Tue, 29 May 2012 16:18:42 -0700
Colin D Bennett <colin AT gibibit DOT com> wrote:

> If you want an elongated (non-square) pad, draw a 'line' where you
> want the rectangular pads, and put the pin in the pad.  Make sure
> you name the pin and pad the same ('n'). (I also always check
> the .fp source to make sure both 'name' and 'number' for pins/pads
> are correct -- copy the footprint and save to a file to examine.)
> 
> See attached .pcb layout for an example of a 5-position connector.

DON'T FORGET to add a pad on the bottom side of the board too,
if needed for your mating edge connector. Thanks Russell for the
reminder.

Regards,
Colin

- Raw text -